Sand & Dust chambers provide an environment to test the exposure of automotive and electronic components to concentrated levels of dust in order to validate product seal integrity.

Pulses of compressed air are blown through a manifold located in the bottom of a collection trough, forcing dust up and over the product. Air pulses are time-programmed for “on” and “off” cycles. Concentration of dust can be easily varied by changing the air pressure and the amount of the blowing time. All dust chambers are designed to meet common test methods such as SAE J575, subparagraph “G”, J.I.S. D-0207-1977, and ASTM C-150-77. Approved dust types are Arizona Dust, Portland Cement Dust, and 213 Silica Sand.

IP5X,IP6X
Model	JQD-800	JQD-1000	JQD-1800
(mm)Internal dimensions	800800800(W·H·D)	100010001000(W·H·D)	100015001200(W·H·D)
Studio temperature range	RT~80℃	RT~80℃	RT~80℃
Test dust	Talcum powder ,Portland cement , Arizona test dust

Aerospace Automotive Electronics Sand and Dust Testing Chamber SAE JIS ASTM Standard

Three Zone Thermal Shock Chamber

Vibration Test Table

Shock Test System

Two Zone Thermal Shock Chamber

Constant Temperature And Humidity Test Chamber

Walk In Environmental Test Chamber

Battery Test Equipment

Agree Chamber

Altitude Test Chamber

Environmental Stress Screening Chamber

High Temperature Aging Chamber

Power Amplifier

Vibration Controller

Slip Table

Head Expander

Salt Spray Test Chamber

Rain Test Chamber

Dust Test Chamber

Xenon Test Chamber

Aerospace Automotive Electronics Sand and Dust Testing Chamber SAE JIS ASTM Standard